Main contents

Dycem mat

Dycem mat

References/construction

Pollution can be efficiently removed by creating an environment
where the dycem mat can be rotated more than
six steps or three or more times.

References

[ Press the arrow button to move to the next case ]
dycemc1
dycemc2
dycemc4
dycemc5
dycemc6
dycemc7
dycemc8
dycemc9
dycemc10
dycemc11
dycemc12
dycemc13
dycemc14
dycemc15
dycemc17
dycemc16
dycemc18
dycemc19
dycemc20


List of materials used during installation

SA Tape (D9605) - Edge attachment tape
F-Sin (DW100) - Dycem mat edge
SA Tape (431) - Mat attachment tape
Coldweld (Cold welding agent) - Cold welding agent for finishing gaps in dycem mat
Measure the mat size in the area where the mat will be installed,
place the mat to be installed, and mark the guideline in advance with a pen
at the place where the mat will be installed.
(On the four edges of the mat, you must leave room for the edge mat. Edge mat size: 10cm)
At this time, the guideline is also marked with a pen where the edge mat will be placed.
After attaching the adhesive tape for the edge mat first in accordance with the pre-marked guidelines
Attach even adhesive tape for Dycem mat.
※ Points to note when attaching adhesive tape
Before attaching the tape, make sure there is no dust or foreign matter in the installation area.
Rub it with a damp cloth and attach it to prevent air bubbles.
After attaching the adhesive tape, cut the overlapped part of the adhesive tape
with a knife and remove it so that there are no overlapping parts.
Install the Dycem mat carefully, removing the adhesive tape from the end according to the guidelines.
※ Points to note when installing Dycem mat
Like attaching adhesive tape, install it so that it does not float by rubbing it with a damp cloth.
Install according to the guidelines indicated in advance.
When the Dycem mat installation is complete, remove the adhesive tape and install the edge mat cut to fit the size.
※ Points to note when installing the edge mat
Install in close contact so that there is no empty space between the Dycem mat
and the edge mat. The adhesive tape on each of the four corners is removed last.
After bonding the edge mats on the four sides, cut the edge mats that overlap each corner.
Cut diagonally, and with the edge mat below,
The upper edge mat must be cut at once so that there is no empty space between the cut edge mats.
When bonding is completed on both Dycem mat and edge mat,
Finish the connected part of Dycem mat and edge mat with cold weld.
When finishing the cold weld, carefully finish between the edge mats cut at each corner
and between the floor and edge mats. (Cold welds are dried in 1-2 minutes.)

Points to note when closing cold welds

1) Place a pointed part like a needle at the entrance between the mat and the mat
(where connection is required) It must be poked and a cold welded finish.
(The solution penetrates between the mat and the mat and becomes adhesive.)
2) If the cold weld solution falls on the edge mat or floor, wipe it off immediately.
However, if the solution falls on the Dycem mat, it is never wiped and the part loses the function of the mat.
Be careful not to get the cold weld solution on the Dycem mat.